Warning Events - IBM TS3100 Setup, Operator, And Service Manual

Warning Events

Warning events described in this section are reported via email notification. The
Attention LED will blink when warning events for the following occur:
v Media
v Fan
v Redundant power supply
An appropriate message will be posted on the Operator Control Panel and the Web
User Interface.
Table 8-3. Warning Events
30 SCSI: transport element full
31 SCSI: all slots empty
32 SCSI: invalid opcode
33 SCSI: invalid element address
34 SCSI: invalid field in CDB
35 SCSI: Invalid drive specified
36 SCSI: SEND DIAGNOSTIC command:
invalid test number
37 SCSI: invalid LUN
38 SCSI: parameter list length error
39 SCSI: parameter list error: invalid field
3A SCSI: parameter list error: parameter not
supported
3B SCSI: parameter value invalid
3C SCSI: saving parameters not supported
3D SCSI: invalid ID message
3E SCSI: destination element full
3F SCSI: source slot or drive empty
40 SCSI: wrong checksum
41 SCSI: command sequence error
42 SCSI: drive disabled
43 SCSI: I/O Station disabled
44 SCSI: flash image does not fit bootcode
45 SCSI: media removal prevented by drive
46 SCSI: media removal prevented by
library
47 SCSI: flash image does not fit personality Check the version of firmware used for the upgrade.
48 SCSI: drive type not supported in this
library
49 SCSI: incompatible magazine, magazine
not accessible
4A SCSI: source not ready
4B SCSI: destination source not ready
Refer to your host application documentation for problem
determination information.
Check your configuration settings.
Refer to your host application documentation for problem
determination information.
Check whether a version of firmware is available which
supports this drive type. For a list of supported drives, refer
to "Ultrium Tape Drives" on page 1-8.
Check your configuration settings.
Complete move process and retry operation.
8-11
Chapter 8. Error Codes