Input Modes - IBM TS3100 Setup, Operator, And Service Manual

If a library failure occurs, the Ready/Activity LED will turn OFF and the Error
LED illuminates. The Operator Control Panel will also display an appropriate error
code to help identify the failure.
The following are additional operational details of LEDs:
v The Ready/Activity LED is illuminated any time the unit is powered ON and
v The Clean LED is illuminated when either a cleaning requested or a cleaning
v The Attention LED indicates one of the following conditions.
Problem
Bad media
Drive sled issues
Redundant power supply failed
Power supply fan failure
v The Error LED is illuminated when there is an unrecoverable (i.e. hard) drive or

Input Modes

There are several ways to enter values in the different menu items. These values
are selectable predefined values, toggle values (for example, ON/OFF) and
numerical values like network addresses.
functional. The Ready/Activity LED blinks whenever there is library or drive
activity. This LED will also blink when the unit is OFFLINE.
required flag has been issued by the drive. The LED is turned off after a
successful drive cleaning operation.
library failure. This will happen at the same time the hard error message is
displayed on the screen and the LED will remain lit until the error state is
resolved.
Note: From the Operator Control Panel, run Service > Library Verify. If Library
Verify runs without error, the Error LED turns off. If the error persists,
recycle power.
Action Required
1. Go to Monitor > Inventory to locate the defective
cartridge.
2. Move the defective cartridge to the I/O Station.
(Operator Control Panel: Control > Move
Cartridges).
3. Open the I/O Station to remove the defective
cartridge. (Operator Control Panel: Control > Open
I/O).
Do one of the following:
- Install a drive sled (see "Removing/Installing/Adding
a Tape Drive Sled" on page 10-3).
- Modify or resubmit Logical Library setting (Operator
Control Panel: Configure > Logical Libraries or Web
User Interface: Configure Library > Logical Libraries).
- Restore defaults (Operator Control Panel: Configure >
Restore Defaults or Web User Interface: Configure
Library > Restore Defaults).
Complete the following steps:
1. Replace the failed power supply (see "Replacing a
Power Supply" on page 10-11).
2. Cycle library power.
Replace the power supply.
Chapter 2. User Interfaces
2-3