Factory Default Settings - IBM TS3100 Setup, Operator, And Service Manual

Table 5-4. Factory Default Settings (continued)
Restored Item
DHCP
Network IP Mode
Bar Code Label Length Reported to
Host
SNMP
Email Notifications
User Access
Admin
Library Mode
Library Name
Host Name
Logs & Traces Error Log Mode
Path Failover Key
OCP Access PIN
SSL for Web
Drives
Power
Drive 1 SCSI-ID
Drive 2 SCSI-ID
Drive 3 SCSI-ID
Drive 4 SCSI-ID
Drive 1 Loop-ID
Drive 2 Loop-ID
Control Path Drive
Speed
Topology
IPv6 Stateless Autoconfig
Note: * = all settings at library firmware level 4.xx and greater
In some cases, (such as Library Mode), the entry of one option precludes any other
options from being selected. In such cases, the details of the non-applicable options
are not shown.
5-28
TS3100 Tape Library and TS3200 Tape Library Setup, Operator, and Service Guide
Default Setting*
Enabled
IPv4 Only
8
Disabled
Disabled
secure
Random
(Blank)
Continuous
No change
Disabled
Note: The initial Factory Default
setting is disabled. If the OCP Access
PIN setting is changed, executing
"Restore Defaults" will not change the
setting.
Disabled
Power On
4
5
6
8
4
5
Drive 1 only
Auto
LN-Port
Enabled
Comments
Note: DNS server addresses, if
available, will be automatically
assigned. If the DHCP server does
not find any DNS server, the DNS
fields will be set to "0.0.0.0".
Restore from Operator Control Panel
or Web User Interface
(default)
(Depends on MAC Address)
License Key is protected, if
previously entered.
If OCP Access PIN has been enabled
the default PIN is "1234".
(All drives)
SCSI Drives
SCSI Drives
SCSI Drives
SCSI Drives
FC Drives Arbitrated Loop
FC Drives Arbitrated Loop
FC Drives (all)
FC Drives (all)