Populating The Library With Data Cartridges; Finger Holes On Back Side Of 4U Library - IBM TS3100 Setup, Operator, And Service Manual

Figure 4-44. Finger Holes on back side of 4U Library I/O Station

Populating the Library with Data Cartridges

Important: Cartridges placed in the library must be labeled with the correct bar
For information on working with the cartridge magazines, see "Cartridge
Magazines" on page 4-37.
1. Properly label the data cartridges. Refer to Chapter 6, "Using Ultrium Media,"
2. Unlock the cartridge magazines.
3. Remove the selected magazines from the library.
4. Insert cartridges in the magazine(s). Do not store cartridges in the I/O Station
5. Put magazines back into the library. The library will automatically start up and
1
code labels. For additional information, see Chapter 6, "Using Ultrium
Media," on page 6-1.
on page 6-1.
v Using the Operator Control Panel: Control > Magazines select Left or Right.
v Using the Web User Interface: Manage Library > Release Magazine select
Left or Right.
Note: The magazines will relock after 15 seconds if they have not been
removed.
or in the dedicated cleaning cartridge slot. See "2U Library I/O Slot, Storage
Slots and Drive Slot Element Addresses and Physical Locations" on page B-1 or
"4U Library I/O Slots, Storage Slots, and Drive Slots Element Addresses and
Physical Locations" on page B-2 for determining slot location.
perform an inventory check.
Chapter 4. Installation and Configuration
4-41