The 4U Library Configure Library: Logical Libraries Page; The Configure Library: Path Failover Feature Activation Screen; Feature Key Verification Screen - IBM TS3100 Setup, Operator, And Service Manual

The I/O Station and slots reserved for cleaning cartridges, if any, are shared among
all logical libraries.
1. Click Configure Library > Logical Libraries in the left navigation pane.
Figure 4-25. The 4U library Configure Library: Logical Libraries page
2. Select the number of logical libraries you would like to create in your library.
3. Click Submit to create the logical libraries.
Entering Path Failover Feature Activation Key
Path Failover is a combination of two previous features: Control Path Failover (key
entered at the library user interface) and Data Path Failover (key entered at the
device driver interface).
1. Click Configure Library > Path Failover in the left navigation pane.
Figure 4-26. The Configure Library: Path Failover Feature Activation screen
2. Enter the Control Path Failover 12-digit feature key in the spaces provided.
3. Click Activate to save the feature key. The following screen will display if you
Figure 4-27. Feature Key verification screen
Note: A single activation key (available by purchasing Feature Code 1682)
entered at the library user interface now activates both features unless
the LTO-3 drive firmware level is equal to or lower than 73P5 and/or the
library firmware is equal to or lower than 1.95. For either or both of
these two cases, the device driver interface Data Path Failover key
activation will still be required.
have correctly entered the feature key.
Chapter 4. Installation and Configuration
4-25