Configure: Network Menu - IBM TS3100 Setup, Operator, And Service Manual

Ibm system storage tape library
Table of Contents

Advertisement

Configure: Network
DHCP-ON
Figure 5-16. Configure: Network menu
Use these menu items to change the current network settings which allow you to
access the library remotely via a web browser.
v IP Stack - Choose IPv4 only, IPv6 only, or IPv4 & IPv6.
v IPv6 Only and Dual Stack IPv4 & IPv6 - Choose Enable Stateless Auto Config
v DHCP - (Dynamic Host Configuration Protocol) If this is enabled, your library
v IP Address - the IP address of the library
5-24
TS3100 Tape Library and TS3200 Tape Library Setup, Operator, and Service Guide
Configure
Network
IP Stack
DHCP-OFF
(IPv4 & IPv4+IPv6)
IP Address
Address (Web User Interface) or Stateless Autoconfig (Operator Control Panel) if
assigned IPv6 IP addresses are desired. To view the assigned IPv6 addresses
after enabling Stateless Auto Config Address, do the following:
– Operator Control Panel (IPv6 Only): Monitor > Library > Network
If you choose Dual Stack IPv4 & IPv6, you must be prepared to enter both IPv4
and IPv6 IP addresses.
host will negotiate the connection with the library. If DHCP is disabled, the
following information is necessary to establish the remote access.
Netmask
Gateway
Ethernet
DHCP-OFF
(IPv6)
Stateless
autoconfig
Prefix Length
Static IPv6
Address
Gateway
Ethernet

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ts3200

Table of Contents