Ending Procedure; Accessing The Library Using Telnet - IBM TS3100 Setup, Operator, And Service Manual

10. Go to "Ending Procedure."

Ending Procedure

1. Reassemble the drive brick by reversing the steps in "Removing the Drive
2. Reassemble the drive sled by performing the following steps:
3. Install the tape drive sled in the library. Refer to "Installing a Tape Drive Sled"
4. Power ON the library and wait for the library to finish POST (power on self
5. If the cartridge does not eject from the drive, move the cartridge from the drive
6. Run Library Verify before resuming normal library operations. Refer to
7. If necessary, return the failed drive sled to IBM.

Accessing the Library using Telnet

To access a customer's library using telnet, complete the following procedure:
10. Enter exit then press the Enter key to disconnect from the library.
9. Remove the cartridge from the cartridge loader tray.
Cover" on page A-6.
a. Reinstall the drive brick into the sled by performing the following steps:
v Plug in the RS-422 cable, the power cable (if applicable), and the signal
cable.
v Push the drive brick fully into the sled.
v Align the two screws holes on each side of the sled with the screw holes
on each side of the drive brick. DO NOT TIGHTEN THE SCREWS
COMPLETELY.
v After verifying that the drive and sled are properly aligned, fully tighten
the screws.
b. If necessary, perform the following steps to reinstall the connection card and
protective plastic cover on the sled.
v Place the card and the protective plastic cover on top of spacers aligning
the three screw holes. DO NOT TIGHTEN THE SCREWS COMPLETELY.
v After verifying that the connection card and protective plastic cover are
properly aligned, fully tighten the three screws.
on page 10-6.
test), inventory and mid-tape recovery (this can take up to 1 hour).
to the I/O Station (Operator Control Panel: Control > Move Cartridges; Web
User Interface: Manage Library > Move Media), then discard the cartridge.
"Service: Library Verify" on page 5-30.
1. Ask the library administrator to enable the serial port (Operator Control
Panel: Service > Telnet Service Port).
2. Open a Windows Command Prompt screen.
3. Enter telnet [library IP address] then press the Enter key.
4. FLMON> will display.
5. Enter lgi then press the Enter key.
6. Enter service as your Username, then press the Enter key.
7. Enter the service Password, then press the Enter key. Contact your next level
of support for the password.
8. Enter help then press the Enter key for the expanded command menu.
9. To end the telnet session, enter lgo then press the Enter key to log out of the
library.
Appendix A. Information for Trained Service Personnel
A-25