IBM TS3100 Setup, Operator, And Service Manual page 36

Table 1-2. 2U library and 4U library rear panel descriptions
Number Item
1
Power connector(s)
2
Host interface
connectors
3
|
Tape drive sled
4
Shipping lock and
label storage
location
5
USB port
6
Library Control
Board (LCC) LED
7
Serial port
8
Ethernet port
9
Tape drive LED
10
Machine type,
Model number, and
Serial Number
pull-out label
11
Fan vents
12
ESD label
1-4
TS3100 Tape Library and TS3200 Tape Library Setup, Operator, and Service Guide
Description
Both libraries require a 110/220 volt AC power connection.
v The 2U library has one power supply.
v The 4U library has a minimum of one power supply, but has the capability of
adding a redundant power supply.
The library has one or more of the following host interface connectors on the drive
sled:
v Fibre Channel connector
v SFF-8088 mini-SAS connector
This library supports the Ultrium 3, 4, 5, and 6 tape drive. The tape drive in the
library is packaged in a container called a drive sled. Drive sleds come in full high
or half high configurations. The drive sled is a customer replaceable unit (CRU),
and is hot-pluggable, which is designed for easy removal and replacement.
The shipping lock, which secures the accessor during shipping, and associated
label are stored on the rear panel of the library for future use. See "Removing and
Storing the Shipping Lock" on page 4-4.
Note: The shipping lock must be removed before powering ON the library to
allow the accessor to function properly.
Used to save/restore library configuration information on a USB device.
An LED showing the status of the Library Control Board.
LED flashing (1 flash per second) - normal operation
This port is used to communicate serially with the library using an RJ-11 connector.
For use by IBM Service Personnel.
This port is used to connect the library to a network.
LED
v 10/100 Link
– Description: Green: Link Integrity
– Flashing: Network synchronization/negotiation
– Steady (On): Good connection
– Off: No connection between NIC and hub
v Activity
– Description: Amber: Port traffic indicator
– Flashing: Network traffic present
– Steady (On): Heavy network traffic
– Off: No traffic
This LED indicates the current status of the drive. When the LED is green, it
indicates normal drive activity.
The machine type, model number and serial number of the library are located on
this pull-out label. This serial number is the number that links the library to your
warranty.
These vents allow air to escape from the power supply and tape drive sled.
The Electrostatic Discharge label is a reminder that some of the components of this
library are susceptible to electrostatic discharge. See "Electrostatic Discharge" on
page 10-1.