Removing The Drive Cover; Removing The Bezel And The Cover From The 4U Internal Drive - IBM TS3100 Setup, Operator, And Service Manual

Removing the Drive Cover

1. Ground yourself to the drive by using an ESD Kit.
2. Remove the cover of the full high drive by performing the following steps:
Figure A-5. Removing the bezel and the cover from the 4U internal drive
3. Remove the cover of the half high drive by performing the following steps:
A-6
TS3100 Tape Library and TS3200 Tape Library Setup, Operator, and Service Guide
Note: The RS-422 cable is very delicate. Use your fingernails to work the
cable loose before unplugging it.
d. Remove the drive brick from the sled.
a. Using a Phillips screwdriver, remove the three screws and washers (see 1
in Figure A-5) that secure the bezel 2 to the internal drive, then remove
the bezel.
b. Remove the cover of the internal drive by performing the following steps:
1) Remove the four cover-mounting screws and washers 3 .
2) Remove the cover by lifting it up.
1
3
a. To remove the drive bezel, pull the right side of the bezel ( 1 ) from the
front of the drive, then pull the left side of the bezel out of the frame of the
drive.
b. Remove the cover of the internal drive by performing the following steps:
1) Remove the four cover-mounting screws ( 2 ). Two screws are located
on each side of the drive.
2) Remove the cover by lifting it up.
1
2
3