Cables; Drive Power Cable - IBM 7063-CR2 Manual

To Disconnect: 1) Turn off everything (unless instructed otherwise). 2) For AC power, remove the power
cords from the outlets. 3) For racks with a DC power distribution panel (PDP), turn off the circuit
breakers located in the PDP and remove the power from the Customer's DC power source. 4) Remove
the signal cables from the connectors. 5) Remove all cables from the devices.
To Connect: 1) Turn off everything (unless instructed otherwise). 2) Attach all cables to the devices. 3)
Attach the signal cables to the connectors. 4) For AC power, attach the power cords to the outlets. 5)
For racks with a DC power distribution panel (PDP), restore the power from the Customer's DC power
source and turn on the circuit breakers located in the PDP. 6) Turn on the devices.
•
care when handling equipment to avoid cuts, scrapes and pinching. (D005)
Attention:
Failure to follow the step-by-step sequence for FRU removal or installation might result in FRU or
system damage.
For safety, airflow purposes and thermal performance, the service access cover must be installed
and fully seated before you power on the system.
For safety and airflow purposes and thermal performance, if you remove parts from the system,
you must ensure that PCIe tail-stock fillers are present.
Use the following precautions whenever you handle electronic components or cables.
• The electrostatic discharge (ESD) kit and the ESD wrist strap must be used when you handle
logic cards, single chip modules (SCM), multi-chip modules (MCM), electronic boards, and drives.
• Keep all electronic components in the shipping container or envelope until you are ready to
install them.
• If you remove and then reinstall an electronic component, temporarily place the component on
an ESD pad or blanket.
Removing and replacing cables in the 7063-CR2
Learn how to remove and replace cables in the IBM Power Systems HMC (7063-CR2) system.
Removing and replacing the drive power cable in the 7063-CR2
Learn how to remove and replace the drive power cable in the IBM Power Systems HMC (7063-CR2)
system.
Removing the drive power cable from the 7063-CR2 system
To remove the drive power cable from the IBM Power Systems HMC (7063-CR2) system, complete the
steps in this procedure.
Procedure
1. Attach the electrostatic discharge (ESD) wrist strap.
The ESD wrist strap must be connected to an unpainted metal surface until the service procedure is
completed, and if applicable, until the service access cover is replaced.
Attention:
• Attach an electrostatic discharge (ESD) wrist strap to the front ESD jack, to the rear ESD jack,
or to an unpainted metal surface of your hardware to prevent the electrostatic discharge from
damaging your hardware.
2 Power Systems: Servicing the IBM Power Systems HMC (7063-CR2)
Sharp edges, corners and joints may be present in and around the system. Use