Configure: Save/Restore Menu - IBM TS3100 Setup, Operator, And Service Manual

Restore Passwords
Figure 5-19. Configure: Save/Restore menu
v Restore Passwords - This menu item restores the factory default for both the
v Restore all - This menu item restores all factory default settings (refer to
v Restore Library Config - This menu item restores your saved library
v Save Library Config - This menu item saves your library configuration to a USB
Note: Configuration files saved with one version of library firmware may not be
Important: Restoring factory defaults will wipe out all the previous configuration
data.
Table 5-4. Factory Default Settings
Restored Item
Autoclean
Logical Libraries
Active Slots
I/O Station
Encryption
Ethernet Setting
Configure
Save/Restore
Restore All
RMU Admin user access password and the service password.
Table 5-4).
configuration from a USB device. If you have more than one saved configuration
file (.dbb) on your USB device, press Select, then use the up and down keys to
move between the different files. When the correct configuration file is
displayed, press Select again.
device.
Note: Ensure the USB device is formatted for FAT12, FAT16, or FAT32 and does
not use autorun files.
compatible with other versions of firmware. It is recommended to save a
configuration file each time the library firmware is upgraded. Restore the
library using a configuration file that was saved with the same version of
firmware currently installed in the library.
Default Setting*
Disabled
1
Maximum number of slots in library
minus I/O Station
Enabled
None
Auto
Restore Library Config.
Comments
2U library has 1-slot I/O Station.4U
library has 3-slot I/O Station.
License Key is protected, if
previously entered.
Save Library Config.
Chapter 5. Operations
5-27