IBM TS3100 Setup, Operator, And Service Manual page 86

10. Press the DOWN button to highlight SAVE. Press the DOWN again to
4-20
TS3100 Tape Library and TS3200 Tape Library Setup, Operator, and Service Guide
5. If you do not want to select DHCP as your library network setting, skip this
step and proceed to the next step. If you want to select DHCP as your library
network setting, complete the following steps:
a. Press the DOWN button to highlight DHCP.
b. Press the SELECT button to highlight the DHCP field.
c. Press the DOWN button to select ON.
d. Press the SELECT button to apply your selection.
e. Skip to Step 7.
6. Press the DOWN button to select IP Address. For IPv4 only, enter only an
IPv4 address. For IPv6 only, enter only an IPv6 address. For IPv4 & IPv6,
enter an IPv4 address and an IPv6 address.
a. Press the SELECT button to highlight the IP Address field.
b. Press the UP or DOWN button to select the digit(s) in the first octet of
your library's IP Address.
c. Press the SELECT button to highlight the digit(s)in the next octet of your
IP Address.
d. After entering the digits for the last octet, press the SELECT button to
apply your entries.
7. Press the DOWN button to select Netmask. For IPv4, enter only an IPv4
Netmask address. For IPv6, enter only an IPv6 Netmask address. For IPv4 &
IPv6, enter both IPv4 and IPv6 Netmask addresses.
a. Press the SELECT button to highlight the Netmask field.
b. Press the UP or DOWN button to select the digit(s) in the first octet of
your library's Netmask address.
c. Press the SELECT button to highlight the digit(s) in the next octet of your
library's Netmask address.
d. After entering the digits for the last octet of your Netmask address, press
the SELECT button to apply your entries.
8. Press the DOWN button to select Gateway. For IPv4, enter only an IPv4
Gateway address. For IPv6, enter only an IPv6 Gateway address. For IPv4 &
IPv6, enter a Gateway address for both IPv4 and IPv6.
a. Press the SELECT button to highlight the Gateway field.
b. Press the UP or DOWN button to select the digit(s) in the first octet of
your library's Gateway address.
c. Press the SELECT button to highlight the digit(s) in the next octet of your
library's Gateway address.
d. After entering the digits for the last octet in your Gateway address, press
the SELECT button to apply your entries.
9. Press the DOWN button to select Ethernet.
a. Press the DOWN button to highlight the Ethernet field.
b. Press the SELECT button to highlight the Ethernet setting.
c. Press the DOWN button to select a new setting.
d. Press the SELECT button to apply the new setting.
highlight CANCEL. Continue to press the DOWN button to switch between
SAVE and CANCEL.
If SAVE is highlighted, press the SELECT button to apply your new
v
configuration. If changes were made to the Network settings, a pop-up
menu will display the option to reboot the library or cancel the reboot. If