Ha Service; Bond Service - IBM 10G Network Active Bypass User Manual

HA Service

Use the HA Service page to control the segment configuration when the system is used in a
high-availability configuration.
You can use up to two pairs of segments, where one segment in a pair behaves as a secondary (backup)
segment that becomes active if the primary segment fails.
For each pair, the following information is provided:
Table 7. High-availability service settings
Field
State
Primary
Secondary

Bond service

Use the Bond Service page to configure a pair of segments in a bond so that their appliance states are
synchronized. If an appliance in a bonded appliance pair fails (and the segment goes into bypass), the
system sets the other appliance in the pair to bypass mode.
For each pair, the following information is provided:
Table 8. Bond service settings
Field
State
First
Second
16
10G Network Active Bypass V3.4: User Guide
Description
High-availability for the pair is
enabled or disabled
Primary segment of the pair, where
traffic usually flows
Backup segment used if the primary
segment fails
Description
Bonding for the pair is enabled or
disabled
First segment of the pair
Second segment of the pair
Default
Disabled
Default
Disabled