System Settings Procedure; Step 1 Entering System Administration Mode; Step 2 Entering The System Administrator User Id And Passcode - Fuji Xerox DocuCentre-II 2055 User Manual

11 System Settings

System Settings Procedure

To make or change the system settings, it is necessary to enter the System
Administration mode.
This section describes the basic procedures for system settings. The following shows
the reference section for each procedure.
11

Step 1 Entering System Administration Mode

1
Press the <Log In/Out> button.

Step 2 Entering the System Administrator User ID and Passcode

To enter System Administration mode, enter the system administrator User ID. If
[Passcode Entry from Control Panel] in [Login Setup / Auditron Administration] is
activated, the passcode needs to be entered.
It is recommended to change the system administrator user ID and passcode immediately after installing
the machine. For more information, refer to System Administrator Settings (P.351).
1
Enter the user ID with the numeric
keypad or a keyboard displayed by
pressing [Keyboard], and select
[Confirm].
Note
258
Step 1 Entering System Administration Mode .........................................................................258
Step 2 Entering the System Administrator User ID and Passcode ...........................................258
Step 3 Selecting the Operation Mode from the System Administrator Menu ..........................259
Step 4 Selecting an Item on the [System Settings] Screen .......................................................259
Step 5 Setting a Feature ............................................................................................................260
Step 6 Exiting the System Administration Mode......................................................................260
• The default user ID is "11111".
When using the
Authentication feature, a
passcode is required. The
default passcode is "x-admin".
• The machine displays the following message if the system administration login failed:
"Login failed. Re-enter User Details and select Confirm."
• The machine displays the following message if the authentication failed more than the
specified number of times:
"You have made the maximum number of attempts to access the system. Access denied."
1 2 3
4 5 6
7 8 9
0 #
C
<Log In/Out>
button