Fuji Xerox DocuCentre-II 2055 User Manual page 518

16 Problem Solving
Error Code
116-790
123-400
124-701
124-702
124-704
124-709
16
133-210
133-211
133-212
133-213
133-214
133-215
133-216
133-217
133-218
133-219
133-220
133-221
133-222
133-223
133-224
133-226
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
516
Category
C P F S M O
O [Cause]
[Remedy] For Cause 1. Manually staple the first set of the document.
O [Cause]
[Remedy] Turn the machine off and on. If the problem persists,
O [Cause]
[Remedy] Contact our Customer Support Center. Any trays other
O [Cause]
[Remedy] Contact our Customer Support Center. Any trays other
O [Cause]
[Remedy] Contact our Customer Support Center. Any trays other
O [Cause]
[Remedy] Reduce the number of pages, or cancel the stapling
O [Cause]
[Remedy] Turn the machine off and on. If the machine conditions are
O [Cause]
[Remedy] Contact our Customer Support Center.
Cause and Remedy
1. If the operator cancelled printing a document that was
received using the Fax to Mailbox or iFax to Mailbox
feature:
The first set of the document is not stapled.
2. For a cause other than Cause 1:
All the sets of the document are not stapled.
Or, do not cancel printing a document that is received
using the Fax to Mailbox or iFax to Mailbox feature.
For Cause 2. Check if the staple position has been
correctly specified, and try printing again.
Machine malfunction
contact our Customer Support Center.
The output destination was changed to the center tray due
to the malfunction of the specified Side Tray.
than the defective output tray can be used.
The output destination was changed to the center tray due
to the malfunction of the specified Finisher tray.
than the defective output tray can be used.
The output destination was changed to the center tray due
to the malfunction of the specified output tray.
than the defective output tray can be used.
The document exceeded the maximum number of pages
that can be stapled.
setting, then try to print again.
An error occurred during fax transmission.
not improved by performing the relevant remedy, contact
our Customer Support Center.
An unsupported country code was specified.