Specifications - Fuji Xerox DocuCentre-II 2055 User Manual

17 Appendix

Specifications

This section lists the main specifications of the machine. Note that the specifications
and the appearance of the product may change without prior notice.
Copy Feature Specifications
Type
Copying method
Scan resolution
Output resolution
Gradation
Warm-up time
Copy document
Development method
Document table type
Photosensitive type
Fusing system
Scanning method
Copy (sheet) size
17
Copy paper
538
Console
Laser xerography
600×600 dpi (23.6×23.6 dots/mm)
600×600 dpi (23.6×23.6 dots/mm)
256 levels
Copier only model:
15 seconds or less (at 20 °C room temperature)
Copier/printer model:
21 seconds or less (at 20 °C room temperature)
Copier/fax or copier/fax/printer model:
24 seconds or less (at 20 °C room temperature)
Important • The value may vary depending on the machine
configuration.
The maximum size is 297×432 mm (A3, 11×17") for both sheets
and books.
Dry development (dual component)
Fixed
OPC
Heat roller
Flatbed scanning using CCD image sensor
[Trays 1 - 4]
Maximum: A3 (297×420 mm), Tabloid (11x17")
Minimum : A5 (148×210 mm)
[Bypass tray]
Maximum: A3 (297x420mm), Tabloid (11x17")
Minimum : Postcard (100×148 mm), Envelope (120×235 mm)
Non-standard size: X direction 99 to 432 mm, Y direction 89 to
297 mm
(When copying both sides of non-standard size paper, specify
the size within the range from 127 to 432 mm for the X direction
and from 89 to 297 mm for the Y direction.
Image loss width:Top edge, 4 mm or less; bottom edge, 4 mm
or less; left and right edges, 4 mm or less
Important • If the X (width) of non-standard size paper is less than 140
mm, documents may not be printed properly.
Paper Tray 1 : 60 - 105g/m
Paper Trays 2 to 4 : 60 - 216g/m
Paper Tray 5 (Bypass): 60 - 216g/m
Important • The use of paper recommended by Fuji Xerox is suggested.
Copying may not be performed correctly depending on the
conditions.
2
2
2