Adjusting The Pick Up Timing; Adjusting The Start-In-Gear Protection Device - Yamaha e60hmhd Service Manual

CONTROL SYSTEM

ADJUSTING THE PICK UP TIMING

CAUTION
Do not adjust the throttle link when it is
operating properly. Excessive adjustment
may cause the engine poor perfomance.
NOTE:
When adjusting the carburetor and adjusting
the ignition timing, always adjust the pick-up
timing.
1. Adjust:
• Pick up timing
Adjusting steps:
(1) Disconnect the link joint 1.
(2) Set the magneto control lever 2 to
fully retard, it contacts the full retard
stopper 3.
(3) Bring the accelerator cam 4 to lightly
contact the throttle lever roller 5.
NOTE:
The throttle valve should not open.
(4) Adjust the length
untill the holes align with the pins on
the magneto control lever 6 and the
accelerator cam 4.
(5) Install the link joint
ADJUSTING THE START-IN-GEAR
PROTECTION DEVICE
1. Adjust:
• Start-in-gear protection device
operation
• Incorrect
2. Adjust:
• Start-in-gear protection device cable
Adjusting steps:
(1) Set the shift control lever to the neutral
position.
(2) Loosen the bolt 1.
(3) Adjust the start-in-gear protection
cable so that the mark
stopper aligns with the mark
cam guide.
(4) Tighten the bolt 1.
3-12
a
of link joint 1
.
1
Adjust.
a
on the
b
E
on the