Adjusting The Pick Up Timing; Adjusting The Throttle Cable - Yamaha E60HWD Service Manual

CHK
ADJ

Adjusting the pick up timing

1. Remove the link rod 1 from the control
lever 2 and cam 3.
4
5
2
1
a
2. Set the control lever 4 to fully retard
position, it contacts the stopper 5.
3. Turn the cam 3 to lightly contact to the
throttle lever roller 6.
NOTE:
The throttle valve should not open.
4. Adjust the length a of the link rod 1 until
the holes align with the set pins on the
control lever 2 and cam 3, and then
install the link rod 1.

Adjusting the throttle cable

NOTE:
Before adjusting the throttle cable, the throttle
stop screw should be properly adjusted.
3-7
Periodic checks and adjustments
6
3
69D30105
1. Loosen the locknut 1, remove the clip 2
and then remove the throttle cable joint
3.
4
2. Set the throttle grip or remote control
lever to the fully closed position.
3. Check that the control lever 4 contacts
the crankcase 5.
4
4. Adjust the position of the throttle cable
joint 3 until its hole aligned with the set
pin on the control lever 4.
1
3
2
69D30085
5
69D30095
a
6D430226
69D5G11