Changing And Checking The Gear Oil Level; Lower Unit - Yamaha e60hmhd Service Manual

LOWER UNIT

LOWER UNIT
CHECKING THE GEAR OIL LEVEL
1. Check:
• Gear oil level
Level is low
proper level.
CHANGING AND CHECKING THE GEAR
OIL LEVEL
1. Check:
• Gear oil
Milky oil
Slug oil Check the oil gears, bearings,
and clutch dog.
Checking steps:
(1) Tilt up the outboard slightly.
(2) Place a container under the gear oil
drain screw 1.
(3) Remove the gear oil drain screw and
gear oil level check screw 2.
2. Fill
• Gear oil
(with the specified amount of the
recommended gear oil.)
Recommended gear oil
GEAR CASE LUBE (USA) or
Hypoid gear oil, SAE #90
Oil capacity:
3
610 cm
Filling steps:
(1) Place the outboard in an upright
position.
(2) Insert the gear oil tube into the drain
hole and slowly fill the gear oil until oil
flows out of the check hole and no air
bubbles are visible.
(3) Install the gear oil level check screw
and then quickly install the gear oil
drain screw.
3-21
Add gear oil to the
Replace the oil seal.
(20.6 US oz, 21.5 lmp oz)
E