Adjusting Trim Angle; Adjusting Boat Trim - Yamaha Z150 Owner's Manual

Operation
EMU27881

Adjusting trim angle

Power trim and tilt models
EWM00750
WARNING
Be sure all people are clear of the out-
G
board motor when adjusting the tilt an-
gle, also be careful not to pinch any
body parts between the drive unit and
clamp bracket.
Use caution when trying a trim position
G
for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
Use the power tilt switch located on the
G
bottom engine cowling (if equipped)
only when the boat is at a complete
stop with the engine off.
Adjust the outboard motor trim angle using
the power trim and tilt switch.
1. Power trim and tilt switch
41
1
DN
UP
1. Power trim and tilt switch
1
1. Power trim and tilt switch
To raise the bow (trim-out), press the switch
" " (up).
To lower the bow (trim-in), press the switch
" " (down).
Make test runs with the trim set to different
angles to find the position that works best for
your boat and operating conditions.
NOTE:
To adjust the trim angle while the boat is
moving, use the power trim and tilt switch lo-
cated on the remote control device or tiller
handle, if equipped.
EMU27911

Adjusting boat trim

When the boat is on plane, a bow-up attitude
results in less drag, greater stability and effi-
ZMU04601
UP
DN
ZMU04615