Accelerator Cable Adjustment - Suzuki Engine 2002 GRAND VITARA SQ420 Service Manual

ENGINE AND EMISSION CONTROL SYSTEM (H25 ENGINE) 6E2-17

Accelerator Cable Adjustment

1) Warm up engine to normal operating temperature. And
check to make sure that fast idle control cam is off cam fol-
lower lever, if not check fast idle control system referring to
"Throttle Body" in this section.
2) With throttle valve closed, check accelerator pedal play
which should be within following specification.
If measured value is out of specification, adjust accelerator
cable (1) to specification with cable adjusting nut (2).
Accelerator pedal play
"a" : 2 – 5 mm (0.08 – 0.19 in.)
3. Lock nut
3) With accelerator pedal depressed fully, check clearance
between throttle lever (2) and lever stopper (1) (throttle body)
which should be within following specification.
Clearance between throttle lever and lever stopper (With
pedal depressed fully)
"b" : 0.5 – 2.0 mm (0.02 – 0.07 in.)
If measured value is out of specification, adjust it to specification
by changing height of pedal stopper bolt (3).