REMOVAL
1) Disconnect negative cable at battery.
2) Drain engine coolant and disconnect inlet hose from radiator.
3) Remove power steering pump belt (4) or A/C compressor
belt, if equipped.
4) Remove radiator cooling fan, water pump pulley, water pump
drive belt and fan shroud.
1. Crankshaft pulley
2. P/S pump pulley
3. A/C compressor (if equipped)
5) Remove crankshaft pulley by removing 5 pulley bolts (1).
6) Remove timing belt outside cover.
7) For installation of timing belt, align 4 timing marks as shown
in figure by turning crankshaft.
1. "V" mark on cylinder head cover
2. Timing mark by "E" on camshaft timing belt pulley
3. Arrow mark on oil pump case
4. Punch mark on crankshaft timing belt pulley
ENGINE MECHANICAL (G16 ENGINE) 6A1-17