Suzuki Engine 2002 GRAND VITARA SQ420 Service Manual page 402

14) Remove crankshaft pulley bolt.
To lock crankshaft pulley (1), use special tool (camshaft pul-
ley holder) as shown in figure.
Special tool
(A) : 09917-68221
CAUTION:
Be sure to use the following bolt (2) for fixing special tool
to crankshaft pulley.
Bolt size : M8, P1.25 L = 45 mm
Strength : 7T
3. Wrench
15) Remove crankshaft pulley (1).
If it is hard to remove, use special tools (Steering wheel
remover, Bearing puller attachment) as shown in figure.
If bolts of steering wheel remover are too long, replace them
with those of suitable length.
Special tool
(B) : 09944-36011
(C) : 09926-58010
16) Disconnect CKP sensor connector and remove CKP sensor
if necessary.
17) Remove timing chain cover.
CLEAN
Clean sealing surface on timing chain cover, crankcase, cylinder
block and cylinder heads.
Remove oil, old sealant, and dust from sealing surface.
INSPECTION
Check oil seal lip for damages or deterioration.
Replace as necessary.
ENGINE MECHANICAL (H25 ENGINE) 6A2-27