6A1-10 ENGINE MECHANICAL (G16 ENGINE)
CLEAN
Blow off dust by compressed air from air outlet side of element.
INSTALLATION
Reverse removal procedure for installation.
Cylinder Head Cover
REMOVAL
1) Disconnect negative cable at battery.
2) Remove ignition coil assemblies with high-tension cord.
3) Disconnect PCV valve and breather hose from head cover.
4) Detach accelerator cable from clamp.
5) Remove cylinder head cover (1) with cylinder head cover
gasket (2) and O-rings (3).
INSTALLATION
1) Install O-rings (2) and cylinder head cover gasket (1) to cylin-
der head cover (3).
NOTE:
Be sure to check each of these parts for deterioration or
any damage before installation and replace if found
defective.