6A1-70 ENGINE MECHANICAL (G16 ENGINE)
1. Cylinder block
2. Front oil seal
3. Main bearing
: Do not apply engine oil between cylinder block
and bearing, between bearing cap and bearing.
4. Bearing cap
5. Cap bolt
6. Timing pulley key
11. Housing bolt (short)
7. Crankshaft
12. Oil seal housing
: Apply sealant 99000-
31250 to mating surface.
8. Thrust bearing
13. Housing bolt (long)
9. Rear oil seal
14. Input shaft bearing
10. Pin
15. Flywheel
REMOVAL
1) Remove engine assembly from body referring to "Engine
Assembly" in this section.
2) Remove clutch cover, clutch disc and flywheel (drive plate for
A/T).
Special tool
(A) : 09924-17811
1. Flywheel bolt
3) Remove crankshaft pulley, timing belt and crankshaft timing
pulley.
4) Remove cylinder head assembly.
5) Remove oil pan and oil pump strainer.
6) Remove oil pump (1).
2. Bolt
7) Remove oil seal housing.
8) Remove connecting rod bearing caps.
16. Flywheel bolt
Tightening turque
Do not reuse.
Apply engine oil to sliding
surface.