Table of Contents
Advertisement
6C-8 ENGINE FUEL
Fuel pump assembly bolt
Fuel tank bolt
Fuel tank protector bolt
Breather hose clamp
Fuel filler hose clamp
8) Connect fuel filter inlet hose (3) to fuel filter (1).
9) Connect coupler to fuel pump assembly and tank pressure
10) Connect negative (–) cable to battery.
11) Upon completion of installation, check fuel system for leak-
Fuel Tank Purging Procedure
The following procedure is used for purging the fuel tank.
1) After removing fuel tank, remove all hoses and fuel pump
2) Drain all remaining fuel from tank.
3) Move tank to flushing area.
4) Fill tank with warm water or tap water, and agitate vigorously
5) Completely flush out remaining water after washing.
Tightening Torque Specification
Fastening part
2. Fuel filter outlet hose
sensor respectively.
age.
CAUTION:
This purging procedure will NOT remove all fuel vapor.
Do not attempt any repair on tank where heat or flame is
required, as an explosion resulting in personal injury
could occur.
assembly from fuel tank.
and drain. Repeat this washing until inside of tank is clean.
Replace tank if its inside is rusty.
N•m
5.0
50
2.0
4.0
Tightening torque
kg-m
lb-ft
0.5
3.5
5.0
36.5
0.2
2.0
0.4
3.0
Hide quick links:
Advertisement
Chapters
Table of Contents
