Suzuki Engine 2002 GRAND VITARA SQ420 Service Manual page 570

25) Install lifting device.
26) Remove engine side mounting bracket nuts from engine
mountings.
27) Before lifting engine, check to ensure all hoses, wires and
cables are disconnected from engine.
28) Remove engine assembly from chassis and transmission by
lifting a little, sliding toward front, and then, carefully hoist
engine assembly.
INSTALLATION
Reverse removal procedure for installation noting the following
points.
1) Lower engine assembly into engine compartment. Connect
engine to transmission and engine side mounting brackets to
engine mountings.
2) Tighten nuts fastening engine side mounting brackets and
engine mountings.
Tightening torque
Engine side mounting bracket nut
(a) : 55 N·m (5.5 kg-m, 40.0 lb-ft)
3) Tighten bolt and nuts fastening cylinder block and transmis-
sion to specified torque.
Tightening torque
Transmission to cylinder block bolt and nut
(a) : 85 N·m (8.5 kg-m, 61.5 lb-ft)
4) Remove lifting device.
5) Tighten torque converter bolts to specified torque (for A/T
vehicle).
Tightening torque
Torque converter bolt
(a) : 65 N·m (6.5 kg-m, 47.0 lb-ft)
ENGINE MECHANICAL (J20 ENGINE) 6A4-81