6A1-4 ENGINE MECHANICAL (G16 ENGINE)
On-Vehicle Service
Compression Check
Check compression pressure on all four cylinders as follows :
1) Warm up engine.
2) Stop engine after warming up.
NOTE:
After warming up engine, place transmission gear shift
lever in "Neutral" (shift selector lever to "P" range for A/T
model), and set parking brake and block drive wheels.
3) Disconnect fuel injector wire harness connector.
4) Remove ignition coil assemblies and all spark plugs referring
to "Spark Plug" and "Ignition Coil Assembly (Igniter and Igni-
tion Coil" in Section 6F1.
5) Install special tool (Compression gauge) into spark plug
hole.
Special tool
(A) : 09915-64510-001
(B) : 09915-64510-002
(C) : 09915-64530
(D) : 09915-67010