Cooling Fan Belt - Suzuki Engine 2002 GRAND VITARA SQ420 Service Manual

6B-22 ENGINE COOLING

Cooling Fan Belt

REMOVAL
For G16 and H25 engines
1) Disconnect negative (–) cable at battery.
2) Loosen P/S pump drive belt adjusting bolt and then remove
P/S pump belt.
3) Loosen adjusting bolt (1) and pivot bolt.
4) Slacken belt by displacing generator and then remove it.
For J20 engine
1) Disconnect negative (–) cable at battery.
2) Loosen adjusting bolt (1) and pivot bolt (2).
3) Slacken belt by displacing fan pulley.
4) Remove cooling fan. Just detach the fan/clutch from fan pul-
ley.
5) Remove cooling fan belt (3).
INSTALLATION
For G16 and H25 engines
1) Install belt to water pump pulley, crankshaft pulley and gen-
erator pulley. Install P/S pump drive belt.
2) Adjust belt tension as specified. Refer to "Cooling Fan Belt
Tension Check and Adjustment" in this section.
3) Tighten adjusting bolt and pivot bolt.
4) Connect negative (–) cable at battery.
For J20 engine
1) Install belt to fan pulley and crankshaft pulley.
2) Install cooling fan. Refer to "Cooling Fan and Fan Clutch" in
this section.
3) Adjust belt tension as specified. Refer to "Cooling Fan Belt
Tension Check and Adjustment" in this section.
4) Tighten adjusting bolt and pivot bolt.
5) Connect negative (–) cable at battery.
COOLING FAN BELT TENSION INSPECTION
Inspect belt and check belt tension. Refer to "Cooling Fan Belt
Tension Check and Adjustment" in this section.