Crankshaft Position Sensor (G16 Engine) - Suzuki Engine 2002 GRAND VITARA SQ420 Service Manual

6E1-48 ENGINE AND EMISSION CONTROL SYSTEM (G16/J20 ENGINES)
INSTALLATION (G16 ENGINE)
1) Check that O-ring is free from damage.
2) Check that CMP sensor and signal rotor tooth are free from
any metal particles and damage.
3) Install CMP sensor to sensor case.
Tightening torque
CMP sensor bolt
(a) : 9 N·m (0.9 kg-m, 6.5 lb-ft)
4) Connect connector to it securely.
5) Connect negative cable to battery.

Crankshaft position sensor (G16 engine)

INSPECTION
Check crankshaft position sensor referring to Steps 2 and 3 of
"DTC P0335 Diag. Flow Table" in Section 6. If malfunction is
found, replace.
REMOVAL
1) Hoist vehicle.
2) Disconnect connector (1) from crankshaft position sensor
(2).
3) Remove crankshaft position sensor from oil pan.
INSTALLATION
1) Check to make sure that crankshaft position sensor and pul-
ley tooth is free from any metal particles and damage.