Dtc P0443 Evap Control System Purge Control Valve Circuit Malfunction - Suzuki Engine 2002 GRAND VITARA SQ420 Service Manual

6-1-116 ENGINE GENERAL INFORMATION AND DIAGNOSIS (H25 ENGINE)

DTC P0443 EVAP Control System Purge Control Valve Circuit Malfunction

WIRING DIAGRAM
[A] : Terminal arrangement of ECM (PCM) coupler viewed from harness side
1. Main fuse
DTC DETECTING CONDITION AND TROUBLE AREA
DTC DETECTING CONDITION
Monitor signal of EVAP canister purge valve is different from
command signal. (Circuit open or short) (2 driving cycle
detection logic)
DTC CONFIRMATION PROCEDURE
WARNING:
• When performing a road test, select a place where there is no traffic or possibility of a traffic acci-
dent and be very careful during testing to avoid occurrence of an accident.
• Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE:
Check to make sure that the following conditions are satisfied when using this DTC CONFIRMATION
PROCEDURE.
• Intake air temperature : between –14°C and 70°C (6.8°F and 158°F)
• Atmospheric pressure : higher than 560 mmHg (Altitude : lower than 2790 m (9150 ft))
1) Connect scan tool to DLC with ignition switch OFF.
2) Turn ON ignition switch and clear DTC, pending DTC and freeze frame data by using scan tool.
3) Start engine and warm up it completely.
4) Increase vehicle speed to 40 km/h (25 mph) or more.
5) Keep driving above vehicle speed for 5 min. or more (Change of vehicle speed is permitted in this step).
6) Release accelerator pedal, stop vehicle and run engine at idle speed for 2 min.
7) Check DTC and pending DTC by using scan tool.
2. Main relay
3. EVAP canister purge valve
TROUBLE AREA
• EVAP canister purge valve and its circuit
• ECM (PCM)