Table of Contents
Advertisement
6E1-34 ENGINE AND EMISSION CONTROL SYSTEM (G16/J20 ENGINES)
Fuel pressure regulator
REMOVAL
1) Relieve fuel pressure according to procedure described on
"Fuel Pressure Relief Procedure" in Section 6.
2) Disconnect battery negative cable from battery.
3) Disconnect vacuum hose (1) from fuel pressure regulator
(2).
4) Remove fuel pressure regulator from fuel delivery pipe.
CAUTION:
A small amount of fuel may be released when it is from
delivery pipe.
Place a shop cloth under delivery pipe so that released
fuel is absorbed in it.
5) Disconnect fuel return hose from fuel pressure regulator.
INSTALLATION
For installation, reverse removal procedure and note following
precautions.
• Use new O-ring.
• Apply thin coat of gasoline to O-ring to facilitate installation.
• Tighten fuel pressure regulator bolts to specified torque.
Tightening torque
Fuel pressure regulator bolt
(a) : 11 N·m (1.1 kg-m, 8.0 lb-ft)
• With engine "OFF" and ignition switch "ON", check for fuel
leaks around fuel line connection.
Hide quick links:
Advertisement
Chapters
Table of Contents
