Shutdown Method; Forced Shutdown - Ricoh D146 Service Manual

Notes on the Main Power Switch
In rare cases, when you reconnect the AC power cord to a power outlet, the machine does not
start automatically. In this case, the machine has not failed. The cause is due to the timing of
releasing the residual charge. If you press the main power switch while the residual charge was
already released, the power ON flag will not be set. At this time, start the machine manually by
pressing the main power switch.

Shutdown Method

1. Press the main power switch [A] on the machine.
2. The shutdown message is displayed. Wait for 3 minutes for the machine to shut down.
§
After the shutdown process, the main power is turned off automatically.
§
Before removing and adjusting electrical boards, do the following procedure. Otherwise,
the board can be damaged by the residual charge inside the machine and must be
replaced.
1. Take out the power cord after shutdown.
2. Press the power switch for a second to remove the residual charge inside the machine.

Forced Shutdown

In case normal shutdown does not complete for some reason, the machine has a forced shutdown
function.
To make a forced shutdown, press and hold the main power switch for 6 seconds.
In general, do not use the forced shutdown.
§
Forced shutdown may damage the hard disk and memory, and can cause damage to the
machine. Use a forced shutdown only if it is unavoidable.
D146/D147/D148/D149/D150 4-2 SM