Ricoh D146 Service Manual page 117

Caster Table Type M3
⇒
1. Attach the 3 locating pins.
2. Holding the grips on the machine, align with the locating pin, and place the machine on the
caster table.
When you lift the machine, hold the lifting handles.
In particular, do not lift it by holding the scanner unit, etc., (as it may deform). .
Do not put the machine down on the caster table as a temporary resting place. This
may cause the machine to deform. Always connect the machine and caster unit
properly.
3. Pull out the 2nd paper feed tray.
4. Using a securing bracket, fix the machine to the paper tray unit (spring washer : screw:
M4×10: 1).
5. Attach the securing brackets [A] at 2 positions to left and right at the rear of the machine
(screws: 1 each).
6. Return the paper feed tray to the machine.
D146/D147/D148/D149/D150
The pins, screws, and
brackets can be located on
the stabilizer.
2-46
Rev. 3/11/2014
SM