Ricoh D146 Service Manual page 524

Service Call 501-584
SC No. Level
SC503-34 B
D146/D147/D148/D149/D150
Error Name/Error Condition/Major Cause/Solution
§
Paper overload
§
Paper set fault
§
Limit sensor error/connector missing
§
Lower limit sensor error/connector missing
§
Harness broken
§
Bank control board defective
§
Foreign matter, such as paper scrap, is caught inside the
right tray
§
Reset the paper
§
Remove the foreign matter
§
Reset the connector
§
Replace the harness
§
Replace the sensor
§
Replace the control board for the optional paper feed tray
3rd Tray Paper Position Error (LCIT)
During left/right tray set, or when power is switched ON, or when
transfer is complete, "open" is detected 3 times consecutively by
end fence open/close detection.
(up to 2 times consecutively, LCIT transmits "tray set fault" to the
main machine)
§
Paper set fault (paper is offset from position for pushing end
fence)
§
Foreign matter entry (foreign matter is caught in the position
for pushing end fence)
§
End fence open/close sensor error/connector missing
§
Harness broken
§
Bank control board defective
§
Reset the paper
§
Remove the foreign matter
§
Reset the connector
§
Replace the harness
§
Replace the sensor
§
Replace the control board for the optional paper feed tray
5-50 SM