Selecting The Program Number; Exiting Service Mode - Ricoh D146 Service Manual

Types of SP Modes

1.2.3 SELECTING THE PROGRAM NUMBER

Program numbers have two or three levels.
1. Refer to the Service Tables to find the SP that you want to adjust before you begin.
2. Press the Group number on the left side SP Mode window that contains the SP that you want
to adjust.
3. Use the scrolling buttons in the center of the SP mode window to show the SP number that
you want to open. Then press that number to expand the list.
4. Use the center touch-panel buttons to scroll to the number and title of the item that you want
to set and press it. The small entry box on the right activates and shows the below default or
the current settings.
§
Refer to the Service Tables for the range of allowed settings.
5. Do this procedure to enter a setting:
§
Press to toggle between plus and minus and use the keypad to enter the appropriate
number. The number you enter writes over the previous setting.
§
Press to enter the setting. (The value is not registered if you enter a number that is
out of range.)
§
Press "Yes" when you are prompted to complete the selection.
6. If you need to perform a test print, press Copy Window to open the copy window and select
the settings for the test print. Press Start
window to return to the SP mode display.
7. Press Exit two times to return to the copy window when you are finished.

1.2.4 EXITING SERVICE MODE

Press the Exit key on the touch-panel.
D146/D147/D148/D149/D150
and then press SP Mode (highlighted) in the copy
1-4 System Maintenance Section