Ricoh D146 Service Manual page 533

SC No. Level
SC509-00 B
SM
Error Name/Error Condition/Major Cause/Solution
SI By-pass Side Fence Drive Motor Error
SI by-pass tray performs control to drive the side fence, and
bring it against the paper.
If the drive does not stop after the maximum drive time set for
each operation mode, the error is detected.
1. Side fence contact operation
§
Drive stop trigger: One side of the fence will be a
non-contact state.
§
Maximum drive time: 1350 msec
§
Side fence drive motor: CW
2. Side fence pushing operation
§
Drive stop trigger: Both of the fences will be a contact
state.
§
Maximum drive time: 4200 msec
§
Side fence drive motor: CCW
If the error is detected, a message is displayed "after re-set the
paper size in the paper can be pulled through the paper. Should
fit the paper guide plate" that.
Accumulated count of error detection are 3 (CW) or 13 (CCW),
the SC is displayed on the operation panel.
In addition, the accumulated count is reset under the following
conditions.
a Turn the power off/on
b If the by-pass side fence is back correct adjustment
c Return from sleep
§
SI by-pass side fence drive motor connector missing, error,
step out
§
SI by-pass side fence paper contact sensor connector
missing, error
§
by-pass paper end sensor error
5-59
Service Call 501-584
D146/D147/D148/D149/D150