Ricoh D146 Service Manual page 526

Service Call 501-584
SC No. Level
SC503-36 B
D146/D147/D148/D149/D150
Error Name/Error Condition/Major Cause/Solution
3rd Tray Transfer HP Error (LCIT)
§
HP detection error (during transfer start)
At right tray paper end (right tray lower limit detection, left
tray paper detection), left tray paper is transferred to the
right tray, but the left tray transfer fence HP sensor is
detected although a predetermined time elapsed (HP
sensor missing cannot be detected)
§
HP detection error (during transfer fence HP return)
During left tray transfer fence HP not detected (stop after
paper transfer, during power supply ON, during left tray set),
the left tray transfer fence is moved to HP, but the left tray
HP sensor is not detected although a predetermined time
elapsed.
*If an error occurs 3 times consecutively: LCIT transmits
"3rd paper feed tray transfer HP error" to the main machine.
(up to 2 times consecutively, LCIT transmits "tray set fault"
to the main machine)
§
Transfer motor error/connector missing
§
Left tray transfer fence HP sensor error/connector missing
§
Harness broken
§
Bank control board defective
§
Paper overload
§
Foreign matter, such as paper scrap, is caught between the
left tray and the tray transport motor
§
Paper set fault
§
Timing belt damage/dropout
§
Timing pulley damage/dropout
§
Transfer fence defective
§
Foreign matter, such as paper scrap, is caught inside the
left tray
5-52 SM