Disassembly And Replacement - Toshiba e-STUDIO281c Service Manual

17.7 Disassembly and Replacement

[A] Automatic Duplexing Unit (ADU)
(1) Take off the right front hinge cover.
( P.2-28 "[I] Right front hinge cover")
(2) Take off the right rear hinge cover.
( P.2-31 "[P] Right rear hinge cover")
(3) Remove 1 screw (M4*12), open the bypass
tray and take off the bypass feed front cover.
(4) Disconnect 1 connector and remove 1 screw
fixing the ground wires.
(5) Remove 2 screws and take off the bracket.
(6) Open the ADU. Lift up the ADU a little and
slide it to the rear side and take it off.
e-STUDIO281c/351c/451c
AUTOMATIC DUPLEXING UNIT (ADU)
Bypass feed front cover
Screw
Screw
Bracket
ADU
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
17 - 12
Fig. 17-8
Connector
Ground wire
Fig. 17-9
Fig. 17-10