Toshiba e-STUDIO281c Service Manual page 396

[K] Lower transport roller
(1) Take off the ADU board.
( P.17-13 "[D] ADU board (ADU)")
(2) Take off the ADU cover.
( P.17-14 "[E] ADU cover")
(3) Remove 2 clips, 2 pulleys and 2 pins on the
front side. Then take off the timing belt.
(4) Remove 1 clip and 1 bushing on the rear
side.
(5) Remove 1 bushing on the front side. Then
take off the lower transport roller.
[L] ADU entrance sensor (S38)
(1) Take off the ADU cover.
( P.17-14 "[E] ADU cover")
(2) Disconnect 1 connector. Release the latches
and take off the ADU entrance sensor.
e-STUDIO281c/351c/451c
AUTOMATIC DUPLEXING UNIT (ADU)
Pin
Belt
Lower transport roller
Clip
Bushing
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
17 - 18
Pin
Pulley
Pulley
Clip
Fig. 17-26
Bushing
Fig. 17-27
ADU entrance sensor
Fig. 17-28
Clip