Toshiba e-STUDIO281c Service Manual page 311

(3) Disconnect 1 connector and remove 2
screws. Then take off the internal cooling
fan.
[C] Revolver home position sensor (S8)
(1) Take off the left cover (
cover").
(2) Disconnect 1 connector and remove 1 screw.
Then take off the revolver home position sen-
sor with the whole bracket.
[D] Revolver motor (M12)
(1) Take off the LGC board case (
LGC board case").
(2) Disconnect 1 connector and remove 2
screws and take off the revolver motor.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
P.2-29 "[K] Left
P.2-38 "[F]
13 - 9
Internal cooling fan
Fig. 13-7
Revolver home position sensor
Fig. 13-8
Revolver motor
Fig. 13-9
e-STUDIO281c/351c/451c
13
REVOLVER UNIT