Toshiba e-STUDIO281c Service Manual page 326

(9) Take off the transfer belt cleaning unit.
[B] Transfer belt
Note:
It is recommended to wear gloves to avoid a direct touch on the belt surface.
(1) Take off the transfer belt cleaning unit
( P.14-8 "[A] Transfer belt unit / Transfer
belt cleaning unit").
(2) Remove 1 screw and take off the right rail.
(3) Remove 1 screw on the front side and 1
screw on the rear side. Then lay down the
tension roller.
e-STUDIO281c/351c/451c
TRANSFER UNIT
Screw
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
14 - 10
Transfer belt cleaning unit
Fig. 14-9
Right rail
Fig. 14-10
Screw
Tension roller
Fig. 14-11