Toshiba e-STUDIO281c Service Manual page 369

[G] Separation finger
(1) Take off the fuser roller
( P.16-23 "[E] Fuser roller / Fuser belt
guide").
(2) Lift up the fuser belt unit and take it off.
Note:
Be careful not to scratch the fuser belt. Lay
the fuser belt on the clean place to prevent
the belt from the dust.
(3) Confirm that the pressure releasing levers on
both sides are up. Then loosen each 1 screw
on both front and rear sides.
(4) Remove 2 springs.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fuser belt unit
Fig. 16-34
Pressure releasing lever
Fig. 16-35
Fig. 16-36
16 - 27
Screw
Pressure releasing lever
e-STUDIO281c/351c/451c
FUSER UNIT / PAPER EXIT SECTION
16