Toshiba e-STUDIO281c Service Manual page 313

[F] Revolver unit
(1) Take off all of the color developer units
( P.12-21 "[B] Color developer unit").
(2) Take off the process unit (
Process unit").
(3) Take off the left inner cover (
Temperature/humidity sensor (S19)").
(4) Take off the left rear cover
( P.2-29 "[M] Left rear cover").
(5) Take off the color auto-toner sensor
( P.12-31 "[F] Color auto-toner sensor
(S10) / Color auto-toner sensor shutter sole-
noid (SOL1)").
(6) Take off the color toner cartridge sensor
( P.13-8 "[A] Color toner cartridge sensor
(S9)").
(7) Take off the internal cooling fan
( P.13-8 "[B] Internal cooling fan (M20)").
(8) Take off the revolver home position sensor
( P.13-9 "[C] Revolver home position sen-
sor (S8)").
(9) Take off the laser optical unit (
Laser optical unit").
(10) Release 2 latches take off the laser cooling
duct cover (rear side).
(11) Pull out the handle. Remove 2 screws and
take off the laser cooling duct cover (front
side).
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
P.11-10 "[B]
P.11-23 "[P]
Laser cooling duct cover (rear side)
P.8-11 "[A]
Laser cooling duct cover (front side)
13 - 11
Fig. 13-12
Fig. 13-13
e-STUDIO281c/351c/451c
REVOLVER UNIT
13