Toshiba e-STUDIO281c Service Manual page 392

[E] ADU cover
(1) Take off the ADU.
( P.17-12 "[A] Automatic Duplexing Unit
(ADU)")
(2) Take off the ADU opening/closing switch.
( P.17-13 "[C] ADU opening/closing switch
(S37)")
(3) Remove 4 screws and take off the ADU
cover.
[F] Paper guide
(1) Take off the ADU.
( P.17-12 "[A] Automatic Duplexing Unit
(ADU)")
(2) Release the fulcrum on the front side and
take off the paper guide.
[G] ADU clutch (CLT7)
(1) Take off the ADU cover.
( P.17-14 "[E] ADU cover")
(2) Remove 1 E-ring and disconnect 1 connec-
tor. Then take off the ADU clutch.
Note:
When installing the E-ring, make sure that
the latches of both ends of E-ring are on the
flat part of the shaft.
e-STUDIO281c/351c/451c
AUTOMATIC DUPLEXING UNIT (ADU)
2
Paper guide
ADU clutch
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
17 - 14
ADU cover
Fig. 17-14
1
Fig. 17-15
Shaft
E-ring
Fig. 17-16