Toshiba e-STUDIO281c Service Manual page 214

(12) Remove 1 screw and take off the bracket.
(13) Remove 1 E-ring, 1 bearing, 1 clip and 1
bushing. Remove 5 screws and take off the
gear cover.
[H] Main motor (M6)
(1) Take off the rear cover-2 (
cover-2").
(2) Take off the LGC board case
( P.2-38 "[F] LGC board case").
(3) Take off the SYS board case
( P.2-35 "[D] SYS board case").
(4) Disconnect 1 connector, remove 4 screws
and take off the main motor.
e-STUDIO281c/351c/451c
DRIVE SYSTEM
Gear cover
P.2-32 "[S] Rear
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
9 - 20
Fig. 9-40
Clip
Bushing
Fig. 9-41
Connector
Main motor
Fig. 9-42
Bracket
E-ring
Bearing