[E]
Fuser roller / Fuser belt guide
Note:
When installing/disinstalling the fuser
roller, make sure not to remove the spring
(shown in the figure at right) since the
removal of this spring may have the fuser
roller press to deform the thermistor.
(1)
Remove the cleaning unit
(
P.16-19 "[B] Oil roller").
(2)
Remove the IH coil (
(IH-COIL)").
(3)
Push down the pressure releasing levers on
both sides.
(4)
Remove 1 C-ring and 2 gears.
(5)
Remove 1 bearing.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
P.16-22 "[D] IH coil
16 - 23
Spring
Fig. 16-22
Pressure releasing lever
Fig. 16-23
Fig. 16-24
FUSER UNIT / PAPER EXIT SECTION
Spring
C-ring
Gear
Bearing
e-STUDIO281c/351c/451c
16