Toshiba e-STUDIO281c Service Manual page 378

(3) Disconnect 1 connector and take off the IH
control board cooling fan.
[P] Exit motor (M7)
(1) Take off the fuser unit.
( P.16-19 "[A] Fuser unit")
(2) Take off the IH board case.
( P.16-34 "[N] IH board (IH) / IH board
case")
(3) Disconnect 1 connector, remove 1 screw and
take off the exit motor.
Note:
When the exit motor is being installed, install
it by sliding the motor to the left side to nar-
row the distance between the shafts of the
gear.
e-STUDIO281c/351c/451c
FUSER UNIT / PAPER EXIT SECTION
IH control board cooling fan
Connector
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
16 - 36
05/08
Fig. 16-61
Exit motor
Fig. 16-62
Fig. 16-63