Toshiba e-STUDIO281c Service Manual page 210

Note:
Reassemble the registration clutch so as to
match the end of the shaft with that of the
clutch as shown in the right-hand figure.
(16) Disconnect 1 connector, remove 2 screws,
and take off the bracket.
(17) Loosen 1 setscrew, take off the upper trans-
port clutch (High speed) with the gear.
Note:
Do not mix up the registration clutch and
upper transport clutch (High speed) when
installing them.
e-STUDIO281c/351c/451c
DRIVE SYSTEM
0
Bracket
Connector
Setscrew
Gear
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
9 - 16
Fig. 9-28
Fig. 9-29
Upper transport
clutch (High speed)
Fig. 9-30