Toshiba e-STUDIO281c Service Manual page 131

No. Message
22 Ready for bypass feeding
23 COPYING
24 Auto Start
25 Close Large Capacity
Feeder
26 Close Large Capacity
Feeder Door
27 Place Doc. Feeder in the
down position
28 Place originals in the docu-
ment feeder
29 Change direction of original Displayed when the direction of origi-
30 Place last %d originals in
doc.
feeder entrance tray
31 Cannot copy this original
32 Add paper
33 Cannot duplex this size
34 Cannot use this media type Displayed when the paper size which
35 Copy size: A4/LT only
36 Copy size: A4/LT and A4-
R/LT-R
37 CHANGE DRAWER TO
CORRECT PAPER SIZE
38 Change drawer to correct
media type
39 Select a paper size for
bypass feeding
40 Place the blank sheets in
bypass tray and select the
paper size
41 Place the blank sheets in
the same direction as the
originals
42 Place the same size blank
sheets as the originals
43 Place insertion sheets in
the bypass tray and select
the paper size
44 Select the same size
insert1 sheets as the origi-
nals
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
State of equipment
Paper is set on the bypass tray
At the copying state
Auto Start is set during printing
LCF drawer is not installed when
feeding from LCF is set
LCF cover is open when feeding from
LCF is set
RADF is open when original is placed
on RADF
Displayed when the conditions are
set and [START] button is pressed
with no original placed
nal placed is different from the setting
Paper jam occurred during copying
(RADF scanning)
Displayed when the original which is
not allowed to be copied is placed
Displayed when the paper in
selected drawer is running out
Displayed when the paper size which
is not specified for duplex copying is
set
is not specified for the functions such
as stapling or hole punching is set
Displayed when the paper size which
is not specified for "Book-type duplex
copying" or "Dual-page" is set
Displayed when the paper size which
is not specified for "Rotate Sort"
Displayed when the selected paper
size is not in the drawer
Displayed when the selected media
type is not in the drawer
Displayed when paper size needs to
be specified for bypass feeding such
as duplex copying
Displayed when no paper is in the
selected feeder at Cover Copying
Mode
Displayed when the direction of
cover page is different from that of
other pages at Cover Copying Mode
Displayed when the paper size of
cover page is different from that of
other pages at Cover Copying Mode
Displayed when no insertion sheet is
in the selected drawer at Sheet Inser-
tion Mode
Displayed when the size of insertion
sheet (sheet 1) is different from that
of other pages at Sheet Insertion
Mode
5 - 5
Note
Cleared by pressing [FUNCTION
CLEAR] button
Cleared by installing LCF drawer
Cleared by closing the cover
Cleared by closing RADF
Cleared by setting the original
Not printed out
e-STUDIO281c/351c/451c
CONTROL PANEL
5